Cooling
Room-by-room comfort without ductwork — efficient heating and cooling for additions, condos, and hard-to-reach spaces.
Ductless mini-splits solve the problems central air cannot. If you have a finished attic that never cools, a basement apartment, a sunroom addition, a converted garage, or a century home in Leslieville or the Annex with no ductwork at all, a mini-split delivers heating and cooling to that space without tearing open walls and ceilings to run ducts.
The system is simple: a slim outdoor condenser connects through a small wall penetration to one or more indoor heads. Each head has its own thermostat, so you are conditioning only the rooms you are actually using. On a modern inverter mini-split, that combination of zoned control and variable-speed operation is dramatically more efficient than pushing cold air through a leaky duct system to a room nobody is in.
Modern cold-climate models also heat, and heat well — many maintain useful capacity down to −25°C, which makes them a real primary heat source for a Toronto winter rather than a shoulder-season convenience. For basement suites and rental units, that means one compact system handles year-round comfort with no gas line and no ductwork.
NorthPoint handles single-zone and multi-zone installations across the GTA: correct capacity sizing per room, tidy line-set routing that respects how your home looks from the street, proper condensate management, and full commissioning. We will tell you honestly when a mini-split is the right answer and when extending your existing system is the better value.
Finished attics, basement apartments, sunroom additions, converted garages, and century homes in Leslieville or the Annex with no ductwork at all. A mini-split conditions those spaces without opening walls and ceilings to run ducts, which is usually the difference between a project that happens and one that does not.
One outdoor unit can serve one indoor head or several. Single-zone is simplest and cheapest and suits one problem room. Multi-zone puts a head in each space with its own thermostat, so you only condition rooms in use. More heads on one condenser saves outdoor space but ties the zones to a shared capacity, so the sizing per room has to be right.
Modern cold-climate models hold useful heating capacity down to about −25°C, which makes them a genuine primary heat source here rather than a shoulder-season convenience. For a basement suite or rental unit that means one compact system covers the whole year with no gas line and no ducts.
Correct capacity per room, a line-set route that respects how the house looks from the street, condensate handled properly so it never backs up into a finished ceiling, and a wall penetration sealed and flashed correctly. These are the details that separate a tidy install from one you notice every time you pull into the driveway.
“We switched from another plumbing and HVAC service to NorthPoint and we couldn’t be more happy. Their prices are more affordable, their people more knowledgeable, and they get to you fast — especially important when your AC blows out in the middle of summer!”
— B. Parker
“The techs are prompt, friendly and trustworthy. They are knowledgeable and professional, and they explain what they are doing instead of just handing you a bill. I highly recommend them.”
— Barbara K.
“Showed up the same afternoon and explained everything he was doing. Very thorough, polite and professional — and cleaned up the whole area afterward.”
— Aimee B.
A ductless mini-split is often the best solution when:
We size and place the right system for your space:
Toronto's older neighbourhoods are full of homes with boilers and no ductwork, and its condos rarely allow window units. Ductless mini-splits solve both — adding efficient cooling and supplemental heating without a major renovation.
Yes. Cold-climate models are designed to heat efficiently well below freezing, making them a strong supplemental or primary heat source in the GTA.
It depends on your layout and which rooms you want to condition. A multi-zone system can serve several rooms from one outdoor unit.
Very. Because they avoid duct losses and let you condition only occupied rooms, they're among the most efficient options available.
No — indoor heads are very quiet, which is part of why they're popular for bedrooms and offices.
Efficient heat-pump mini-splits often qualify. We will confirm what applies to your install.
Often yes, subject to your building's rules. We can advise on placement and approvals.
