NorthPoint Home Comfort
Instant Quote Call Now

Heating

Furnace Repair in Toronto, Ontario

No heat on a cold night? Our licensed technicians diagnose and repair most furnaces the same day, safely and with upfront pricing.

Furnace Repair in Toronto & the GTA

A furnace that fails in a Toronto January is not an inconvenience, it is a burst-pipe risk. NorthPoint provides fast furnace repair across Toronto and the GTA, including after-hours emergency service, on every major brand of gas, electric, and high-efficiency condensing furnace.

The failures we see most are consistent: a dirty flame sensor shutting the burner down seconds after ignition, a failed igniter, a pressure switch tripping because the condensate trap or vent is blocked, an inducer or blower motor on its way out, a clogged filter causing the limit switch to trip on high temperature, or a control board fault. Our technicians read the diagnostic codes, then verify with actual measurements rather than swapping parts and hoping.

Safety comes first on every gas appliance call. We inspect the heat exchanger for cracking, verify combustion and vent draft, and test carbon monoxide levels. If we find a genuinely unsafe condition we will tell you immediately and explain exactly what we found and why — that is not an upsell, it is the reason you call a licensed contractor.

You approve a written price before any repair begins, and we carry the common failure parts on the truck so most Toronto furnace repairs are finished on the first visit.

What to know before you book a furnace repair

The failures we see most

A dirty flame sensor shutting the burner down seconds after ignition, a failed hot-surface igniter, a pressure switch tripping because the condensate trap or vent is blocked, an inducer or blower motor on its way out, a clogged filter tripping the high-limit, or a control board fault. We read the diagnostic codes and then confirm with measurements rather than swapping parts and hoping.

Safety comes first on a gas appliance

Every call includes a heat exchanger inspection, combustion and vent draft verification, and a carbon monoxide test. If we find a genuinely unsafe condition we will tell you immediately and show you what we found. That is not an upsell — it is the reason you call a licensed contractor rather than a handyman.

Repair or replace?

Under fifteen years with a contained repair, fix it. Past twenty, or facing a cracked heat exchanger or a failed control board on a mid-efficiency unit, replacement is usually the better spend — a modern condensing furnace runs 95–98% against the 60–80% of what you likely have. We quote both.

Same-visit resolution

Our trucks carry the parts that actually fail: igniters, flame sensors, pressure switches, capacitors, thermostats, and common motors and boards. That is why the majority of Toronto furnace repairs finish on the first visit instead of waiting on a parts order in January.

See our work

New high-efficiency gas furnace in a basement mechanical roomCompleted gas furnace installation with clean venting in a tidy basementNew high-efficiency furnace fully installed in a clean utility roomFinished basement mechanical room with the whole heating and cooling system installed

What Toronto homeowners say

“We switched from another plumbing and HVAC service to NorthPoint and we couldn’t be more happy. Their prices are more affordable, their people more knowledgeable, and they get to you fast — especially important when your AC blows out in the middle of summer!”

— B. Parker

“The techs are prompt, friendly and trustworthy. They are knowledgeable and professional, and they explain what they are doing instead of just handing you a bill. I highly recommend them.”

— Barbara K.

“Showed up the same afternoon and explained everything he was doing. Very thorough, polite and professional — and cleaned up the whole area afterward.”

— Aimee B.

Areas we serve

Furnace Repair FAQs

What are the signs I need furnace repair?

Don't wait for a total failure. Call for repair if you notice:

  • Little or no heat, or cold air from the vents
  • Short cycling — turning on and off frequently
  • Banging, rattling, or squealing noises
  • A yellow burner flame instead of steady blue
  • Rising heating bills with no change in usage
  • The furnace won't stay on or won't ignite
What does the NorthPoint furnace repair process look like?
  1. Book & arrive: Call or request online — we schedule fast, often same day.
  2. Full diagnosis: We test the system methodically to find the real fault, not just the symptom.
  3. Written estimate: You get the repair price up front and approve it before we proceed.
  4. Repair & test: We complete the repair and verify the whole system runs correctly.
  5. Prevention advice: We flag anything likely to fail next so you can plan ahead.
Repairs we handle

We diagnose and repair every part of a gas or electric furnace:

  • Ignition & flame sensors — The most common no-heat causes — dirty sensors and failed igniters.
  • Blower motors & belts — Airflow problems that leave rooms cold or overwork the system.
  • Heat exchanger checks — Safety-critical inspection for cracks and carbon-monoxide risk.
  • Controls & thermostats — Faulty boards, wiring, and thermostats that stop reliable heating.
Furnace repair across Toronto & the GTA

From high-efficiency condensing furnaces in newer Vaughan and Markham builds to older mid-efficiency units in Toronto's established neighbourhoods, we repair every type of furnace — and we know how hard GTA winters push them.

Why choose NorthPoint for furnace repair?
  • Safety-first diagnostics — Every furnace repair includes safety checks, including carbon-monoxide risk.
  • Licensed & insured — Fully licensed technicians and full insurance protect your home and your investment.
  • Local GTA team since 2015 — Toronto-based — we know local homes, permits, and the climate we install for.
  • Upfront written pricing — You approve the price before work begins. No surprises, no pressure.
Can you repair my furnace today?

In most cases yes. We prioritize no-heat calls during cold weather across Toronto and the GTA.

Why is my furnace blowing cold air?

Common causes include a failed igniter or flame sensor, a thermostat issue, or a safety lockout. We diagnose the exact cause.

Is a furnace repair safe to delay?

No-heat and any suspected gas or carbon-monoxide issue should be handled immediately for safety. Other issues still get worse if ignored.

Should I repair or replace my furnace?

If your furnace is 15+ years old or the heat exchanger is cracked, replacement is usually safer and more economical. We advise honestly.

Do you repair all furnace brands?

Yes — all major gas and electric furnace brands, regardless of installer.

What if it fails after hours?

See our emergency HVAC repair service for urgent, after-hours heating failures.

Related services

Ready to take the next step?

Get an Instant Quote